The signal strength was fluctuating very often, causing several connect/disconnect sequences within a span of 10 minutes.
The wireless router was located in the first floor of the building, and the signal strength was way too low in the bedroom which is one floor down, and several bends away from the router. It’s obvious that the WAV file is played whenever the system / Wi-Fi adapter establishes connection to the internet. If you are experiencing this problem try using another USB cable or a different USB port on your Mac. Typically this is caused by the USB cable or the Macs USB port. This happens when the connection from your iPad or iPhone to your Mac is not complete. This software seems to run the ConnectToInternet.WAV file located under the Netgear directory. My iPad or iPhone continuously connect and disconnect making a chiming sound. WNA1100.exe is the Netgear configuration software that came with my Netgear WNA1100 (Wireless-N 150 USB) Adapter. So I included '.wav', to start with.Īfter leaving it in Capture mode for about 5 minutes, Process Monitor displayed some relevant events. wav file, but I had a suspicion that it could be, in this case.
With almost a dozen applications running and I didn’t want to disturb them, I fired up the excellent Process Monitor right away, configured the filters so that any entry with '. It was not the Sound Scheme as it was already set to 'No Sounds'. Control Panels – Sounds was the first place where I checked.
